Examples of using Should be installed in English and their translations into Thai
{-}
-
Colloquial
-
Ecclesiastic
-
Ecclesiastic
-
Computer
When using 720 an efficient exhaust hood should be installed to the coating unit due to safety reasons.
When measure gas or steam, vortex flow transducer should be installed at the top of pipeline if the gas or steam contains few liquid.
Should be installed in a dry and ventilated place, avoid sharp, environmental temperature should be in 20~+ 60℃, relative humidity is less than 85.
Sensors, transmitters and cables should be installed to avoid electromagnetic interference, such as away from large motors and relays.
The pressure control valve should be installed at the end of main grease/oil supply pipeline in the terminal type lubrication system.
The pipeline should be cleaned before use, medium is not clean should be installed filter, to prevent impurities interfere with the normal work of the solenoid valve.
If the pipe is not full or the outlet is empty, the sensor should be installed on a siphon.
Important: Insulation should be installed only afterhow to design the humidity of wooden elements of roof pie will be equal to or less than 18.
If the medium is not clean, a filter should be installed to prevent impurities from interfering with the normal operation of the hydraulic solenoid valve.
Air conveyor system stand on the ground by foot support, fans should be installed above the air conveyor.
A grease distributor should be installed after he pressure control valve, so that the grease in the valve will be able to be updated.
If fluid is not high cleanliness, should be installed a filters in front of the solenoid valve, general solenoid valve is better claim to medium cleanness.
If fluid is not high cleanliness, should be installed a filters in front of the solenoid.
The cooler should be installed in a separate low-pressure loop or the system circuit pressure is low, the installation should be tightened seal.
In the case of a flow operation, a stand-pipe for the discharge of the gas should be installed and a gas pump should be applied.
If as the child grows up, there is no confidence in the quality of water from the tap, then a stationary filter of deep cleaning should be installed.
For a gabled roof, sheets on each side should be installed at the same time with the ridge tile.
Application of Saddle Clips: Saddle clip should be installed in the four corners of steel grating and must be fastened to the maximum extent to avoid falling off.
A dual line lubrication distributor should be installed after the pressure switch/ pressure control valve, this lubrication distributor does not need to connect with the progressive distributor for secondary distribution.
The cartridge should be installed perfectly in gun with same mixing ratio and the pushing rod should aim at the center of cartridge bottom.