Примеры использования Charging process на Английском языке и их переводы на Русский язык
{-}
-
Official
-
Colloquial
And the display shows full information about the charging process.
The red(charging) light will blink continuously indicating that the charging process has started.
The yellow light-emitting diode 3 signals the charging process.
It can even display the charging process, but the phone's battery will not recharge.
Remove Li-ion battery from charging bay and repeat charging process, if necessary in another charging bay.
Once the connecting has been verified by the charger the green LED will start to flash to indicate that the charging process has started.
The charging process with optimized energy efficiency is the same as used in the standard BELATRON high efficiency chargers.
During the charging process a specified amount of refrigerant is removed from the cylinder and added to a system.
Possible solution to this problem is a wireless charger that will help to make the charging process more efficient.
With some phones, the charging process can be interrupted or the phone can switch off due to heating up.
The pulse width modulation of charging process increases the service life of lead-acid
Thanks to an optimal charging process of our battery chargers,
With some telephones, the charging process may be interrupted
With some phones, the charging process can be interrupted
If the battery was replaced, but phone still is not charging, most likely the problem is with broken controller, that controls charging process.
can stop the battery charging process.
rechargeable battery is inserted, the charging process starts automatically.
Since the charging processes in capacitors require a little time, the display may
The adaptive feature will automatically optimise the charge process relative to the way the battery is being used.