Exemples d'utilisation de Switch module en Anglais et leurs traductions en Français
{-}
- 
                        Colloquial
                    
- 
                        Official
                    
The switch module can also use active twin-ax copper cables on the 10G Enhanced Ethernet ports.
The switch module is delivered with FC 8G SFP transceivers installed in the four fibre channel ports.
The management interface can be used for any additional configuration of the switch module.
the Dell M8428-k is referred to as the converged network switch  or the switch module.
If required, a serial cable to connect to the switch module serial console port.
In addition to the g-switch, the occurrence ELT model has a 5-axis g-switch module installed.
the attached motor and switch module.
Using the included 1.8 m combo cables, connect the HD15 port connectors on the rear panel of the switch module either to PS/2 ports
acoustic module  MA-1 or switch module MS-1) can be connected with the»iBell« via its lateral connection jack.
configure the uplink ports of the switch module in the same mode.
The individual switching  inputs of the switch module have been permanently assigned to the four DALI circuits:
the switch  Command Line Interface(CLI) to configure the switch module.
crossover cables to connect the network switch module to external network devices, such as switches,  routers, or NICs.
and 0) of the switch module are not compatible with the Ethernet ports 17 through 24.
After modifying the switch module's IP address and domain name(if the switch module is in full fabric mode), we recommend that you cable all external ports to fabric connections before bringing the switch module online.
physical constraints of the M1000e, this switch module when installed would span both fabric B
The REVERSE CAUTION MODE position of the key switch module allows the tractor to be operated in reverse with the blades(PTO) engaged.
The ELT is equipped with a 5‑axis g‑switch module in addition to the usual primary g‑switch,
To set the IP address of the switch module using the switch  CLI via Serial port(rather than through the CMC),
After succesfully setting the IP address of the switch module, a terminal emulator(Telnet, SSH) CLI connection can be established to the converged switch module, from a remote management workstation,