Examples of using Be less in English and their translations into Bengali
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
Not to be imposed on income of annual production must be less than 3000 annual kw.
To qualify for the reduced rate of VAT to 5.5% installed power must be less than 3 kw peak.
When installing or laying cable, the ambient temperature should be less than -20℃, and have to give a preheat to cable.
The bending radius of multi-core cable should not be less than 15 times of the cable diameter.
the area should not be less than the'$literal'.
Also note that the use of the wireless/cordless headphone battery should not be less than 8 hours.
And if all political parties do not participate, voters do not have competitive elections, if they believe that their presence will be less.
For this, usually, the upper section of the upper browser window should be less than the height of the window or in most cases is the same.
And if all political parties do not participate, voters do not have competitive elections, if they believe that their presence will be less.
We warn you, that the university will not be able to make registration for a student if there will be less than 15 days before visa expires.
the width of a ramp should not be less than 0.
on getting the transaction through closing, sometimes we can be less than totally responsive to our clients.
so the strength must be less than 345 in the mechanical design, otherwise there will be problems.
final moisture content can be less 50ppm.
Whatever punishment they receive, however, will be less than they deserve.
So, for concrete posts section size should not be less than 400 mm for masonry not less than 600 mm for masonry 380 mm if it is above ground level,
the local minimum staggered joints shall not be less than 100.
Your wages should be paid in full according to the amount specified in your contract(which should not be less than the prevailing Minimum Allowable Wage when the contract was signed), and not later than 7 days after the end of the wage period.
the inertial fall will be less than 5mm.
It is necessary to adopt round-trip welding, or stratified cross-welding can be adopted, and the amount of welding should be less at each time to prevent the blade from being concentrated by heat and causing stress deformation.