Examples of using Ohms in English and their translations into Indonesian
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Ecclesiastic
the value shall be not less than 2 ohms, or dry processing should be made for motor stator winding,
eg 15 ohms, so that the LED current will be slightly higher, or use a little higher, for example 18 ohms, so that the LED current will be slightly lower.
impedance 2×4 ohms, frequency response 19- 250 Hz, sound pressure level 93 d B and a weight of 26 Kg.
For example, if a glow plug normally reads 1.8 to 3.4 ohms on a hot, running engine, a reading of 1.2 to 1.3 ohms on a glow plug would tell you that cylinder isn't producing any heat.
Typical values of Z0 are 50 or 75 ohms for a coaxial cable, about 100 ohms for a twisted pair of wires, and about 300 ohms for a common type of untwisted pair used in radio transmission.
The current, in accordance with Ohm's law, is inversely proportional to the sum of the internal resistance and the resistor being tested, resulting in an analog meter scale which is very non-linear, calibrated from infinity to 0 ohms.
main grounding electrode and earth of 1 to 5 ohms for large commercial
by using Ohms Law, calculate the battery impedance.
which is roughly equal to 25812.8 ohms, and referred to as the von Klitzing constant RK(after Klaus von Klitzing,
This shoes is made of nubuck leather the sole is dual density pu lining is sandwich mesh it is S1 standard the anti static can bear 100k to 1000m ohms and it is also can meet SRC standard it is the most anti slip standard
This steel shoes for worker shoes which is middle cut the lining is sandwich mesh it can do anti static can bear 100k to 1000m ohms and steel toe protection above 200 joules if with steel midsole plate it will bear above 1100 Newtons and the upper color is black and the color is customized it can use at construction….
then the voltage drop across the contacts using Ohms Law is 0.2 x 10= 2 volts,
A Pt100 probe or sensor cable is a type of resistive temperature detector RTD that will change its resistance as a function of temperature PT100 probe resistance most commonly measures 100 ohms at 0 C and 138 51 ohms at 100 C the temperature range for a Pt100 probe is normally within 200 to 850 C However in practice….
PT100 NTC sensor cable is a type of resistive temperature detector RTD that will change its resistance as a function of temperature PT100 sensors resistance most commonly measures 100 ohms at 0 C and 138 51 ohms at 100 C the temperature range for a Pt100 probe is normally within 200 to 850 C However in practice we….
the grounding resistance is less than 4 ohms, can be used The original ground.
Limit cycle- Mathematical model used to analyze relaxation oscillations When a(neon) cathode glow lamp or thyratron are used as the trigger devices a second resistor with a value of a few tens to hundreds ohms is often placed in series with the gas trigger device to limit the current from the discharging capacitor
which is roughly equal to 25812.8 ohms, and referred to as the von Klitzing constant RK after Klaus von Klitzing,
MEG OHM: One million ohms. .
In addition, we can also use multi tester with OHM range position(Ω).
Unit of resistance: OHM.