Examples of using Ohms in English and their translations into Vietnamese
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
The result tells you that your safe lower limit with the 10-amp battery is 0.47 ohms- anything lower and you risk exceeding
Ohms corrugated copper tube coaxial cable is mainly used for the connection of transmitter, receiver and antenna and also connection between wireless communication equipments
But due to Ohms Law we know that an increase in voltage also leads to a decrease in current, so the overall
Club S115s with a 500-watt program rating, for example, the P5000S with 500-watts per channel into 8 ohms is the obvious choice.
In all Electrical and Electronic circuit diagrams and schematics, the most commonly used symbol for a fixed value resistor is that of a“zig-zag” type line with the value of its resistance given in Ohms, Ω.
several thousand to a million ohms, since the required leakage current at a logic input is small.
being the symbol for ohms of electrical resistance.
would translate to 3.9K; and 470,000 ohms would become 470K.
4 ohms, there is then a measuring error of 4% for a measurement of 0°C, as instead of 100 ohms, 104 ohms is detected.
for example, the P5000S with 500-watts per channel into 8 ohms is the obvious choice.
impressive power output capability, rated for 180 watts into 8 ohms, 360 watts into 4 ohms, and 720 watts into 2 ohms(music signals only).
He wrote that they had a resistance of about 2,000 ohms, which he understood was standard for Navy headsets, but he could not be sure
The 50/ 52 ohm cables are widely used for industrial and commercial two-way radio frequency applications(including radio, and telecommunications), although 75 ohms is commonly used for broadcast television and radio.
the value shall be not less than 2 ohms, or dry processing should be made for motor stator winding, the temperature of the drying
This allows the B 200- 6 Ohm to develop its full potential with none of the impairments caused by frequency-dependent signal-carrying components, while the BG 20- 8 Ohms, that are optimised for low-frequency response, maintain the extremely high sensitivity and beaming effect right
the Light Dependent Resistor(LDR) is made from a piece of exposed semiconductor material such as cadmium sulphide that changes its electrical resistance from several thousand Ohms in the dark to only a few hundred Ohms when light falls upon it by creating hole-electron pairs in the material.
The tolerance of a resistor is the difference between the preferred value(i. e, 100 ohms) and its actual manufactured value i. e, 103.6 ohms, and is expressed as a percentage, for example 5%, 10% etc, and in our example the actual tolerance is 3.6%.
possible analog storage levels), and which typically vary in resistance from 100 ohms to 1 ohm, and cover this range in about 10 seconds with several milliamperes of plating current.
Or light dependent resistors,(LDR) are made from a piece of exposed semiconductor material such as cadmium sulphide that changes its electrical resistance from several thousand ohms in the dark to only a few hundred ohms when light falls upon it by creating hole-electron pairs in the material.
measure the grounding resistance, in general, the grounding resistance is less than 4 ohms, can be used The original ground.