Examples of using Edges in English and their translations into Urdu
{-}
-
Ecclesiastic
-
Colloquial
-
Computer
The outer edges are now slightly pushed apart, so that all four edges each have an approximately 90° angle to each other.
The horizontal line is pressed in from right and left until the edges touch in the middle. The two smooth triangles come to lie on each other. The tip of the resulting triangle points upwards or forwards, ie away from the moth.
There I sew through repeated sewing back and forth. This should be my front neckline. The seam is a few inches away from the edges, as I do not want to see the edge print on the outside of my dress.
Now the loop is sewn to the poncho. Insert the fabric pieces just sewn into the neckline of the poncho. Make sure that the edges are flush with each other.
In our case, strip paper is now visible inside the map. So that they can also write something in, a piece of paper, which is 2- 3 cm smaller at the edges than the side of the card, is glued into it.
Now fold the right, upper tip downwards so that it points vertically downwards. Repeat this process with the left, underneath tip pointing upwards. Fold both tips so that the middle edges are parallel.
Tip: Granted, this technique is a little challenging for inexperienced ones. Once the process is clear, it works very fast in a matter of seconds and creates a noble border on the edges of the paper roses.
Step 6: Now comes the fine-tuning. Now cut the two candles apart on the wick. The candle base, the drip tip is finally processed with the knife, so that no edges or lumps are visible and finished is the homemade beeswax candle!
Now the open edges are sewn with a simple degree stitch, ie the upper edges. Otherwise the jute would fray. Then we put the front and back left to left and sew the remaining three edges together. We can finish the edges with scissors.
in addition it is equipped with edge-cutting device to ensure the valid width and smooth cut of the edges.
Step 2: As the wax melts, place aluminum foil on the table and place the heart shaped cookie cutters on it. Firmly press the edges of the cookie cutters to prevent the wax from leaking afterwards.
Step 6: Now unfold each fold from step 5 and fold it inwards- against the fold, so to speak. The fold edges are hidden inside. Repeat with the other corners as well.
corals will need to be placed accordingly with higher light corals at the center and lower light corals around the edges of the coverage.
in the watches of the night and at the edges of the day, exalt Him, so that you will be pleasing.
Next, we sew the hood to the neckline. We put the boxes right to right, so that the rear hood seam is centered on the back side. Finally, we flip the edges twice and sew them with a simple grand stitch.
By extending the deployment of flaps and trailing edges, the 727 could almost double its bearing surface, which allowed him to fly with great stability at very low speeds Source Wikipedia.
Tip: When folding it is important to ensure that all edges are folded exactly and straight together, as these lines serve as orientation for everything else.
Inner surface opening fences should be colored orange, outer edges of the protective device is not fully harboring dangerous elements of production equipment(fences abrasive wheels, milling cutters, drive belts, chains and m, n.)- yellow.
Step 11: Fold up the bottom corner of the construct along the horizontal fold from the previous steps. Then fold the two folds inwards in the upper area, so that the outer edges of the paper now form the middle. Flatten these edges.
are sure there are no sharp edges anywhere, you are ready to introduce the ferret to their new play room.