Voorbeelden van het gebruik van Nominal size in het Engels en hun vertalingen in het Nederlands
{-}
-
Colloquial
-
Official
-
Ecclesiastic
-
Medicine
-
Financial
-
Computer
-
Ecclesiastic
-
Official/political
-
Programming
The cold duct connection size is equal to the nominal size of the device, and the warm duct connection is one duct size smaller.
The aseptic GEMÜ 567 BioStar control valve is now available up to a nominal size of DN25, thus allowing a maximum flow rate of 15 m³/h.
Nominal size insert- 15* 138 cm be sure to make precise measurements under his cabinet!
colloidal silica of nominal size 30 nm(narrow size distribution).
Depending on the version and nominal size, this enables operating pressures of up to 25 bar
both duct connections are of equal size to the nominal size of the unit.
depending on valve type, nominal size and material.
lower values of the ISO tolerance bands up to nominal size 180 mm.
Description Version: The Tolerator indicates all tolerance values according to ISO recommendation R286- 1962 up to nominal size 500 mm.
use in globe and diaphragm valves with a nominal size of between DN 6 and DN 150.
The earlier hard disks had a nominal size of 5.25" but now days the most common hard disk platter size is 3.5.
High-quality, stainless steel safety pressure gauge with a nominal size of 100 or 160.
The respective higher flow value must be assumed for the calculation of the nominal size.
for spring band clamps up to 70 mm nominal size.
Nominal size(DN)' means a numerical designation of size which is common to all components in a piping system other than components indicated by outside diameters or by thread size. .
cast stainless steel valve bodies up to a nominal size of DN 100.
A small compressor as well as a pressure accumulator are integrated into the functional case- this makes the independent pneumatic air supply to connected devices of small to medium nominal size possible.
The strand shall consist of three wires of the same nominal size, spun together in helical form over a theoretical common axis with a lay length of 14 to 22 times the nominal strand diameter.
whereby the nominal size of the tube to be connected is smaller than that of the fitting body- therefore the reduction.
has been substituted in this standard for such traditional terms as"nominal diameter,""size," and"nominal size.