Examples of using Test controller in English and their translations into French
{-}
-
Official
-
Colloquial
Distributed measurement and control systems are easily configured with Q. bloxx modules and a single test controller many to choose from.
With an integral test controller, the Q. raxx 3U provides 13 expansion slots(for up to 208 channels) with various front panel connector options.
Incorporating an integral test controller, the Q. raxx 3U provides 13 expansion slots(for up to 208 channels) with various front panel connector options.
The test controller manages all of this and provides the time-stamped data to a wide variety of host systems via a wide variety of communication methods- in parallel.
The device is available with a serial interface which can be connected to an external test controller or an integrated controller with an Ethernet TCP/IP and an EtherCAT interface.
The modules are connected in groups to a number of Q. gate test controllers over a high speed serial RS485 interface.
including a choice of test controllers, measurement modules,
The Corrosion Controller test meter should be viewed each time one goes on board.
Keyboard controller error The keyboard controller test failed.
You can test your controller at any time by Clicking on Start,
Communication with a meter under test- the controller is equipped with programmable universal serial port to communicate with the meter under test. .
are simulated by the test bed controller.
Connect the Office Network port on the Aerospace Test Controller to the switch.
For all other test controller is test. .
Usually it is not needed that all Test Controller channels are recorded.
Copy& Paste or Cut& Paste of Test Controller data files.
The communication interface between the Aerospace Test Controller and the Q. series system uses a bi-directional Ethernet communication protocol, which allows for easy configuration and operation.
In addition, for each Aerospace Test Controller a set of Shared Memory channels(virtual calculation channels)
The Aerospace Test Controller buffers its data at either 100, 200, or 500 Hz.
The Q. series system, Moog Aerospace Test Controller, and workstation(s) should all be in the same network range.