英語 での Current flows の使用例とその 日本語 への翻訳
{-}
-
Colloquial
-
Ecclesiastic
-
Computer
-
Programming
If a ripple current flows in a capacitor, heat generation occurs due to losses caused by the internal impedance.
In the case of a solenoid load, an inrush current flows at the initial stage of operation, and constant current flows after several cycles.
These AC-current paths can be seen by eliminating the paths where current flows on both the ON and OFF parts of the switching cycle.
If it is applied a voltage to the case or shaft more than value of dielectric strength, the insulation state is destroyed and current flows.
Because there is no dc current path in this circuit, the load current flows through the smoothing capacitors.
During the low period of the PWM cycle, the CCFLs are turned off and no current flows through them.
For boost and inverting buck-boost topologies, it is only during switch-off time that current flows through the diode.
Electrical current flows by the movement of negative charges(electrons) within the n-type semiconductor.
Given that the ESR for a capacitor is a resistor component, it generates heat when a ripple current flows in the capacitor.
Depending on the temperature difference, an electromotive force is generated in the metal wire, and current flows in the circuit.
Then, as seen in the principle of power generation of DC motors, power-generation action occurs on the coil and current flows through the coil.
When the magnetization directions are antiparallel, the resistance becomes extremely large, and almost no current flows into the barrier layer Fig. 2.
However, in AC/DC conversion, the diode reverse voltage is high and a large reverse current flows, and so discontinuous mode, in which a reverse current does not flow and losses are reduced, is generally used.
It is well known, as a basic property of IGBTs, that when an IGBT is switched off, a tail current flows due to the device structure, and therefore the switching loss is increased.
The Control Systems Diagram(CSD) has the capability of determining pickup and dropout voltages, losses, and current flows at any time instance as well as overall marginal and critical alerts.
As a pulse current flows on and off repeatedly within 10Hz, it is important to understand electrical and magnetic characteristics within a transient state, as well as armature responsiveness when it comes to solenoid design.
When current flows in the windings, magnetic flux is generated in the core, and action in response to a sudden current change makes it difficult for current to flow choke function.
Because of a potential difference from air cell effect, current flows from charcoal to Al. As soon as aluminum cation is supplied to the water and causes hydrolysis, Al hydroxide colloid is generated.
Ghost images result when parasitic current flows through LEDs that are intended to be in an off state(i.e. no current flowing through them); this causes very faint illumination or ghosting.
In differential mode noise, the noise source appears across power supply lines and is in series with the power supply line, and the noise current flows in the same direction as the power supply current. .