THE OUTSIDE DIAMETER - 日本語 への翻訳

[ðə 'aʊtsaid dai'æmitər]
[ðə 'aʊtsaid dai'æmitər]
外側の直径

英語 での The outside diameter の使用例とその 日本語 への翻訳

{-}
  • Colloquial category close
  • Ecclesiastic category close
  • Computer category close
  • Programming category close
The inside diameter of the slip side is is 2 3/8" and the outside diameter of the street side is about 2 3/8".
スリップサイドisisの内径23/8"および通りの側面の外径は約23/8"です。
For hot finished seamless steel tube, the outside diameter tolerance No.1 shall be applied.
熱い終了する継ぎ目が無い鋼鉄管のために、外径の許容No.1は応用です。
It is the basic principle that the threaded bushing is guided firstly to force the outside diameter shrinkage to pack it into the bottom hole smoothly.
ねじ付きブシュが先ず最初に案内されて、外径収縮を強制的に底穴に円滑に充填することが基本原理である。
The outside diameter of a normal pipe bend of VE16(22mm in the outside diameter) becomes similar as well as outside diameter(26mm) of VE22(VP20).
同様にVE16(外径22mm)のノーマルベンドの外径はVE22(VP20)の外径(26mm)と同じになります。
Another available mode has a discrete output and features two point teach capability that can be used to teach the outside diameter and the core diameter of the roll.
これとは別のディスクリート出力が可能なモードもあり、ロールの外側の直径と芯の直径をティーチできる2ポイントティーチ機能があります。
In a word, the outside diameter of a normal pipe bend of VE14(18mm in the outside diameter) becomes it as well as outside diameter(22mm) of VE16(VP16).
つまりVE14(外径18mm)のノーマルベンドの外径はVE16(VP16)の外径(22mm)と同じになります。
Due to this, when matching a hose to an existing pipeline, you also need to know the outside diameter, thickness, and if there is lining present in the pipe.
このため、既存のパイプラインにホースを合わせるときには、外径、厚さ、パイプ内にライニングがあるかどうかを知る必要があります。
As a guide, it is recommended that the stack length be restricted to approximately three times the outside diameter while utilizing the largest possible disc diameter..
ガイドとしては、可能な限り最大のディスク径を利用しながら、スタックの長さは約3倍の外径に制限されることをお勧めします。
Diameter-- For pipe NPS1 1/2(DN40) or smaller, the outside diameter at any point shall not vary more than± 1/64in(0.4mm) from the specified outside diameter.
直径--管NPS11/2(DN40)のためにまたは小さい、外径はいずれかの時点で指定外径からの±1/64in(0.4mm)より多くを変えません。
PVC coated gabions the outside diameter is from 3.0mm to 4.5mm, and the diameter of rim wire or edge wire is one wire gauge thicker than the common mesh wire.
PVCコーティングされた蛇籠外径が3.0ミリメートルから4.5ミリメートルまでであり、そしてリム線又はエッジ線の直径は、一般的なメッシュワイヤよりも太い一つのワイヤゲージです。
In this case, the insulation of the wire is crimped, and therefore the outside diameter of the wire is not taken into account when autoAttaching wire terminals.
その場合、ワイヤの絶縁が圧着されるため、ワイヤ端子を自動接続する際にワイヤの外径は考慮されません。
A second wire has a cross-section of 0.5 mm2, which means the outside diameter calculated on the basis of this cross-section is 0.8 mm.
本目のワイヤの断面積が0.5mm2である場合、この断面積に基づいて計算される外径は0.8mmになります。
The outside diameter of 3.3 mm(hereinafter referred to as ø3 mm), despite with an ultra-small diameter, allows fine positioning of 20 steps per rotation. It aims for adoption in compact, low-profile digital products- such as high-performance cameras for cellular phones and Blu-ray Disc drives for slim-type notebook computers- that was difficult for conventional products.
量産品としては世界最小径(当社調べ)となる外径3.3mmサイズ(以下φ3mm)は、極小径ながら「1回転20ステップ」の微細な位置決めが可能であり、高機能化する携帯電話のカメラや、薄型ノートパソコンのブルーレイディスクドライブなど、従来製品では適用が難しかった小型・薄型デジタル製品に採用されはじめています。
Do the sizes show the outside diameter of PVC water supply pipes?
サイズ表示、給水パイプの外側直径か
Standard inner size is 3 inches with the outside diameter of, 6, 8 and 9 inch.
規格は、内径3インチ、外径6・8・9インチ各種。
NOTE 1 D of this table is the outside diameter of the tubes. NOTE 2 1 Nmm²=1MPa.
この表の注記1Dは管の外径です。注2:1Nmm²=1MPaで。
As the outside diameter of the tires is about 29 inches, the new breed is called the 29er two-niner.
タイヤ外径が約29インチということで、29er(two-niner、トゥーナイナー)と呼ばれるMTBの新ジャンルです。
There is no additional tolerance for ovality on tubes having a nominal wall thickness of more than 3% of the outside diameter.
公称肉厚が外径の3%を超えるチューブには、楕円率に対する追加公差はありません。
There is no addifional tolerance for ovality on tubes having a nominal wall thickness of more than 3% of the outside diameter.
公称肉厚が外径の3%を超えるチューブには、楕円率の追加公差はありません。
Guides may be located on the inside diameter(Di) or on the outside diameter(De) of the springs, but the internal guide is preferred.
ガイドは、内径上に配置することができる(Di)または外径に(De)スプリングスのが、内部ガイドが好ましい。
結果: 379, 時間: 0.035

単語ごとの翻訳

トップ辞書のクエリ

英語 - 日本語