Examples of using The terminal in English and their translations into French
{-}
-
Official
-
Colloquial
Unscrew the terminal screws and remove the wires that need changing.
Remove the cover of the terminal box from the downdraft unit Fig.21.
Attach the terminal cover to prevent short circuit.
Do not install the terminal in an area where condensation occurs.
Replace the 3 nuts on the terminal block see Figure 4.
Open the cover of the terminal box on the control console.
Use a Phillips screwdriver and remove the terminal box cover.
Keep the supplied cap to cover the terminal when it is not in use.
Slide the terminal cover(2) onto the red cable 5.
The terminal site shall be selected in such a way that.
Turn the terminal cap counterclockwise to loosen it.
Do not loosen the terminal screws further than the mechanical stop.
Push the terminal firmly into the camera.
Never leave the access cover off the terminal block.
Close the terminal box and assure that it is properly sealed.
It covers the terminal and marks the city's entrance
Ensure that the terminal screws are tightly holding all wires in place.
Wire up and then insert the terminal blocks into the card"A.
Can be installed between the terminal element and the mounting adapter.
The Terminal Code does not apply to these Via Rail stations.
