Examples of using Deflection in English and their translations into Finnish
{-}
-
Colloquial
-
Official
-
Medicine
-
Financial
-
Ecclesiastic
-
Official/political
-
Computer
-
Programming
Also, the curvature or deflection of the central line of the tongue can occur with an acute stroke,
this time observing the deflection of the needle on the meter.
This solution allows installing the Adaptive Crowning with the advantage to measure the ram deflection and to compensate in real time,
minimize agitator deflection.
The force Ff shall be applied for a minimum of five seconds following the cessation of the visually detectable deflection.
it is 5° C and allows the deflection of one degree.
heat deflection, and direct support of live electrical parts.
because it can happen to close the wiring or the deflection of ceiling beams, trusses collapse.
jaw deflection becomes significant.
Solid shaft designs will have less deflection than hollow shafts of similar diameter, promoting better mixing action.
A complete characteristic curve representing the deflection of the suspension system must be plotted from zero load to maximum load, and back to zero.
First, the exercises associated with the deflection of the spine cause the adrenal glands to work harder,
dramatically reduces deflection and noise.
the stability of the blank is not good and the deflection is easy due to the absence of friction between the liquid
caused by a deep or sharp deflection, and occurs at the point of impact on a restricted area.
The main drawback of placing self-leveling floor on a wooden surface- the possibility of cracking the structure as a result of the deflection boards under the weight of the finished floor.
Excessive shaft deflection, due to dynamic loading, will increase the
The loading test is carried out by measuring strain, deflection, sag and displacement in bridge girders
In the case of seats with a mass adjustment scale, the characteristic curves representing the deflection of the suspension system are plotted at mass adjustments for drivers having a mass of 50 and 120 kg.
The main reason for this difference is the number of cracks in the crack tip area and the degree of deflection of the crack.